MIL-C-48286 Charge, Mine Ejection Assembly, M198

Pages 1 - 2 - 3 - 4 - 5 - 6 - 7 - 8 - 9 - 10 - 11 - 12 - 13

MIL-C-48286A (PA)

Pushout Test of Primer. - Fifty (50 ) charge assemblies

less propellant and wad, shall be subjected to the test as specified

in 4.4.1.

d. Internal resistance of charge assembly. - Two hundred

and seventy five (275) charge assemblies shall be subjected to the

test as specified in 4.4.2. .

e. Immersion (Leakage) test, - Fifty (50) charge assemblies

shall be subjected to the test as specified In 4.4.3.

f. Non-functioning. - One hundred and twenty five (125 )

charge assemblies shall be subjected to the test as specified

in 4.4.4.

g. Environmental tests (see 3.5-). - Sixty (60) charge

assemblies, after being subjected to and passing the non-function

tests of 4.2.2.f, shall be subjected to the environmental tests

as specified in 4.4.6. After the environmental tests they shall

be functioned as specified in 4.4.5. The charge must function

but does not have to comply with the output criteria to be accept-

able for this test group.

h. Functioning (wet), (see 4.3.3.6.2). - The fifty (50)

charge assemblies, previously subjected to and passing the

immersion test, shall be subjected to the test as specified in

4.4.5.

i. Functioning (dry) (see 4.3.3. 6.3) - Eighty (80)

charge assemblies that have been previously subjected to and

passed the internal resistance test, shall. be subjected to the

test as specified in 4.4.5.

j. Insulator Dielectric Strength. - Fifty (50) charge

assemblies, less propel lant and wad shall be assembled using an

inert primer pin and shall be subjected to the test as specified

in 4.4.7.

4.2.3 Rejection. - If any component, sub-assembly or assembly

fails to comply with any or all of the applicable requirements,

the first article sample shall be rejected. The Government re-

serves the right to terminate its inspection upon any failure of'

an inert component, sub-assembly or assembly to comply with any

of the stated requirements.