MIL-M-45424D (MU)
Thread pitch diameter, 2 places . . . ..Gage
10.
06014
Boss diameter incorrect, 2 places. . .Gage
11.
06015
Counterbore diameter . . . . . . . . . . Gage
12.
06016
Optional hole diameter oversize . . .Gage
13.
06017
Optional hole depth oversize . . . . . .Gage
14.
06018
Small adapter hole diameter . . . . . .Gage
15.
06019
Countersink missing or inadequate. . . Visual
16.
06020
4.3.6 Dimensional control of stamped parts.-To qualify
a new or reworked tool to be used in the stamping process for
use in production, a sample of at least ten (10) parts shall
be fully inspected dimensionally. As a control of each tool
during production, the above quantity of parts from each tool
shall be inspected for at least the defects specified in
4.3.6.1 through 4.3.6.3 after each hours production. If any
defective parts are found during qualification of the tool it
shall not be used in production. If any defective parts are
found when inspection is performed for the control of the
tool, the tool producing the defect shall be removed from
production. Further, that portion of production since the
last control check shall be returned to the contractor for
inspection for each separate type of defect according to
MIL-STD-105, using an AQL of 0.40 percent for each major
defect and an AQL of 0.65 percent for each minor defect. All
tools removed from production because of some fault, may
after reworking, be returned to production providing they
pass the qualification test above. The contractor may request
a change of inspection frequency providing he presents
objective evidence to the contracting officer to substantiate
the request. The following subparagraphs identify those Items
and minimum inspections subject to the requirements of this
paragraph. A defect classification of Minor is assigned to all
defects listed herein.
4.3.6.1 Bracket, angle (see dwg. 8800907 covering a
detail of dwg. 8885262).
Defects
Code No.
Method of
Inspection
Bend angle . . . . . . . . . . . . . . . . . . Gage
1.
08001
2.
Hole location, 2 places . . . . . . . . . . Gage
08002
13