MIL-T-46238E (MU)
4.2.2 First article inspection provisions.
4.2.2.1 Component parts and subassemblies.
4.2.2.1.1 Submission.-Twenty-five (25) complete sets of
parts (i.e. 25 each of every component parts and subassembly,
including at least three (3) items from each cavity used to
produce plastic parts and so identified as to permit tracing
each item to the cavity in which it was molded).
4.2.2.1.2 Inspections to be performed.-The parts and sub-
assemblies will be subjected by the Government to any or all of
the applicable examinations and tests specified in 4.3.2, 4.3.3
and 4.3.5 of this specification and any or all of the requirements
of the applicable drawings.
4.2.2.1.3 Rejection.-If any component or subassembly fails
to comply with any of the applicable requirements, the first
article sample shall be rejected. The Government reserves the
right to terminate its inspection upon any failure of a component
or subassembly to comply with any of the stated requirements.
4.2.2.2 Test set assemblies
4.2.2.2,1 Submission.-Thirty (30) test sets completely
packaged and sealed as required by the applicable drawings.
4.2.2.2.2 Inspections to be performed.-The thirty (30)
test sets shall be subjected to the following tests in the
sequence indicated in addition to the inspections specified in
4.3.2.9:
a.
Functioning (see 3.5.1) in accordance with 4,4.2.
b.
Functioning (see 3.5.2) in accordance with 4.4.3.
c.
Five foot drop test (see 3.3) in accordance with 4.4.4.
4.2.2.2.3 Rejection.-If any test set fails to comply with
any of the applicable requirements, the first article sample
shall be rejected. The Government reserves the right to terminate
its inspection upon any failure of the test set to comply with
any of the stated requirements.
4.3 Inspection provisions
4.3.1 Lot formation.-The term "inspection lot" as used
in this specification is defined as an essentially homogeneous
collection of units of protiuct from which a representative
5
For Parts Inquires call Parts Hangar, Inc (727) 493-0744
© Copyright 2015 Integrated Publishing, Inc.
A Service Disabled Veteran Owned Small Business