MIL-T-46238E (MU)
3.6 Functioning of lamp.-The lamp (see dwg. 9275725) shall
function satisfactorily and shall not blow out when connected
in series with a fifteen (15) ohm resistor and tested as
specified in 4.4.8.
3.7 Workmanship.-All parts and assemblies shall be
fabricated and finished in a thorough workmanlike manner.
They shall be free of burrs, chips, sharp edges, cracks,
crazes, unblended radii, porosity, warpage, burn marks,
checks, chipped edges, blisters, excess flash, dirt, grease,
rust, salt deposits, visible raised cement seams, solder
splash, corrosion products, and other defects and foreign
matter which would affect their serviceability. The cleaning
method used shall not be injurious to any part norshall the
parts be contaminated by the cleaning agent. All required
markings shall be neat and sharply defined.
3.8 First article inspection.-This specification makes
provisions for first article Inspection. Requirements for the
submission of first article samples by the contractor shall be
as specified in the contract.
4.
QUALITY ASSURANCE PROVISIONS
4.1 Responsibility for inspection.-Unless otherwise speci-
fied in the contract or purchase order, the supplier is respon-
sible for the performance of all inspection requirements as
specified herein. Except as otherwise specifted In the contract
or order, the supplier may use hts own or any other facilities
suitable for the performance of the inspection requirements
specified herein, unless disapproved by the Government. The
Government reserves the right to perform any of the inspections
set forth In the specification where such inspections are deemed
necessary to assure supplies and services conform to prescribed
requirements. Reference shall be made to MIL-STD-109 to define
terms used herein. The provisions of MIL-A-2550 shall apply.
4.1.1 Submission of product.-At the time each completed
lot of Items deliverable under the contract is submitted to
the Government for acceptance, the contractor shall supply the
following information accompanied by a certificate which attests
that the information provided is correct and applicable to the
product being submitted:
a. A statement that the lot complies with all of the
quality assurance provisions specified in this specification.
b. Drawing and specification number and date, together
with identification and date of changes thereto.
3
For Parts Inquires call Parts Hangar, Inc (727) 493-0744
© Copyright 2015 Integrated Publishing, Inc.
A Service Disabled Veteran Owned Small Business