MIL-F-48293A(PA)
3.3 Fuze assembly
*3 .3.1 Jolt and Jumble. - The fuze shall not arm when the
safety slip is properly installed and the assembly is tested as
specified in Paragraph 4.5.8.10.
*3.3.2 Mechanical Arming. - The safety and Arming Mechanism
shall function (explosive train full in-line) when shocked to the
force-time requirements specified by curve No. 1.
3.3.3 Fuze resistance. - The resistance between the
curved spring and the non-insulated terminal shall not ex-
ceed two (2) ohms when tested as specified in 4.5.8.4.
3.4 Mechanical properties. - Cold-working or heat-treating
(including quenching-and-tempering, normalizing, normalizing-and-
tempering, annealing, and stress-relieving) operations, shall be
performed in such a manner as to produce the specified properties
uniformly throughout the entire lot.
3.5 Workmanship. - All parts and assemblies shall be fabri-
cated and finished in a thorough, workmanlike manner.
They shall
be free of burrs, chips, sharp edges, cracks, unblended radii, sur-
face defects, dirt, grease, rust, corrosion products, and other
foreign matter. The cleaning method used shall not be injurious
to any parts, nor shall the parts be contaminated by the cleaning
agents . All marking and stamping shall be neat and sharply defined.
3.6 Submission of results of contractor-conducted examina-
tions and tests. - The contractor shall forward copies of the
results of any of his examinations or tests to the designated
address as specified in paragraph 6.4.
First Article Inspection. - This specification makes
3.7
provisions for first article inspection. Requirements for the
submission of first article samples by the contractor shall be
as specified in the contract.
4.
QUALITY ASSURANCE PROVISIONS
*4.1 Responsibility for Inspection and Standard Quality
Assurance Provisions. - Unless otherwise specified herein or
in the contract, the provisions of MIL-A-48078 shall apply and
are hereby made a part of this specification.
*4.2 Classification of Inspections. - The following types
of inspection shall conducted on this item:
3
For Parts Inquires call Parts Hangar, Inc (727) 493-0744
© Copyright 2015 Integrated Publishing, Inc.
A Service Disabled Veteran Owned Small Business