MIL-DTL-50512A
4.5 Methods of inspection.
4.5.1 Ammunition lot numbering. Visually verify that ammunition lot number has been
applied to each lot as described in MIL-STD-1168.
4.5.2 Workmanship. Visually verify that all parts and assemblies meet requirements of
3.5.
5. PACKAGING
5.1 Packaging. For acquisition purposes, the packaging requirements shall be as specified
in contract or order (see 6.2). When actual packaging of materiel is to be performed by DoD or
in-house personnel, these personnel need to contact the responsible packaging activity to
ascertain packaging requirements. Packaging requirements are maintained by the Inventory
Control Point's packaging activity within the Military Service or Defense Agency, or within the
military service's system command. Packaging data retrieval is available from the managing
Military Department's or Defense Agency's automated packaging files, CD-ROM products, or
by contacting the responsible packaging activity.
6. NOTES
(This section contains information of a general or explanatory nature that may be helpful,
but is not mandatory.)
6.1 Intended use. The Mine, APERS, Practice M68 with accessories is an anti-personnel
mine inert used in training personnel.
6.2 Acquisition requirements. Acquisition documents should specify the following:
a. Title, number and date of this specification.
b. Applicable stock number.
c.. Packaging requirements, if other than specified in Section 5.
d.. Serialization requirements, if applicable.
e. Certificate of conformance for each lot or shipment of product.
6.3 Drawings. Drawings listed in section 2 of this specification under the heading U.S.
Army Armament, Research, Development and Engineering Center (ARDEC) may also include
drawings prepared by, and identified as U.S. Army Armament, Research and Development
Command (ARRADCOM), Frankford, Rock Island, or Picatinny drawings. Technical data
originally prepared by these activities is now under the cognizance of ARDEC.
6.4 Submission of inspection equipment designs for approval. Submit equipment designs
as required to Commander, ARDEC, ATTN: RDAR-QEM-G, Picatinny, NJ 07806-5000. In
addition, inspection equipment used for acceptance of product should be capable of repeatable
measurements, by various experienced inspection/test personnel, to an accuracy of 10% of the
11
For Parts Inquires call Parts Hangar, Inc (727) 493-0744
© Copyright 2015 Integrated Publishing, Inc.
A Service Disabled Veteran Owned Small Business