MIL-F-48235 (MU)
quantities presented for inspection. Homogeneity shall be
considered to exist provided the inspection lot has been pro-
duced by one manufacturer, in one unchanged process, using
the same material and methods, in accordance with the same
drawings, same drawing revisions, same specifications and same
specification revisions and comlplies with the provisions for
submission of product as specified in M1L-STD-105. Changes to
the process, specification, or drawing not affecting safety,
performance, interchangeability, or storage, as determined by
the Government, shall not be deemed to alter the homogeneity
of an inspection lot. All material submitted for inspection
in accordance with this specification shall comply with the
homogeneity criteria specified herein regardless of the type
of sampling procedure which is being applied to determine con-
formance with requirements. Lot numbering, as required, shall
be in accordance with MIL-STD-1168. Each inspection lot of
firing devices shall contain parts from not more than one lot
interfix number from one manufacturer.
4.3.2 Examination. - The examinations listed in the
following subparagraphs shall be performed on inspection lots
(see 4.3.1) of the components or assemblies designated in
the applicable paragraph headings. Inspection for critical
defects (and major defects, when so specified) shall be 100 per-
cent. Sampling plans for major and minor defects shall be in
accordance with MIL-STD-105 except that continuous sampling
plans in accordance with MIL-STD-1235 may be used if approved
by the Government. Instead of applying the AQL's designated
herein to the groups of major and minor defects listed, the
contractor may elect to apply AQL's to individual defects using
an AQL of 0.40 percent for each major defect and an AQL of 0.65
percent for each minor defect. When this method is" ejected, it
shall be applied to all of the major and minor defects listed in
the applicable subparagraph of this section, except where 100
percent inspection is specified, and be documented as part of
s
the contractor inspection system. Equipment necessary for the
performance of the inspections listed shall be in accordance with
4,3,4.
4.3.2.1 Housing (see dwg. 8800936 covering a detail of dwg.
8837124).
Categories
Defects
Method of
Code No.
Inspection
(see 6.2)
Critical:
None Defined
7
For Parts Inquires call Parts Hangar, Inc (727) 493-0744
© Copyright 2015 Integrated Publishing, Inc.
A Service Disabled Veteran Owned Small Business